Please read these
instructions, completely, before starting.
The installation is done mostly from the side of the bike with the seat
and side covers off.
Items you may need are something that resemble the following:
- long (8-10”) straight edge screwdriver
- Phillips screwdriver
- regular pliers
- needle nose pliers
- large file
- 10” long adjustable wrench
- long thin narrow kitchen knife
- long flat piece of bendable metal (9”x1”x1/8”) with no sharp edges
- a Dremel tool or something that will cut the base of the seat
- a 6" block of dense foam rubber, a 10-12” square, clean shop rag or old washcloth will due
- a large towel or blanket (not wife's dress)
Please note that the instructions are for a seat with an existing 1"x3" access hole in the bottom. For seats without an existing hole, please refer to, modifying your seat, for help before continuing with installation.
When referring to the left, right, top, bottom, front, back or side, it is in relation to the seat being on the bike in riding position.
Placement of the device is preferably located at dead center where you sit on the seat. It is most noticeable and comfortable in this location. Installing the device too far forward may cause the unit to operate less effectively, as a result.
If, at any time, these
instructions are unclear, please stop immediately and e-mail us
for assistance at sales@blinkerbuddy.com.
Please include your phone number, available hours and what time zone you
are in. Make sure you elaborate on each question and include as much detail
as possible.
We will answer you promptly.
The white
box indicates the final desired position of the device as shown on these
stock seats.
The red box indicates the existing entry hole used on a stock seat assembly.
Fig. 1
Interstate seat
The green
box indicates the area where a hole could be made on an after market seat.
A hole in this area would not have to be covered over. A hole directly
under the device would have to be covered to prevent the device from falling
out.
Make the hole only big enough to fit the device through.
Fig. 2
Standard / Tourer seat
This is where you attach the wires. Connect to the bottom part of the Orange and Light Blue wire connectors.
Fig. 3
Under the right "side cover" of the bike.
home | info | FAQ | install | contact | order | warranty | legal | links
